1. JAL

    JAL Feb 24, 2018

    Posts
    4
    Likes
    0
    Hello everybody!! My first post - I just pre ordered my Connected 45 pack (comes along with Automatic Calibre 5).

    I have found where to configure AOD active or inactive for an specific watch face but neither where to setup the brightness level when AOD will be active or where to setup the amount of time to wait to activate AOD.

    Maybe these parameters are not configurable on Andoid 2.0 ???

    Kind regards,

    JAL.
     
  2. pfrasun

    pfrasun Feb 26, 2018

    Posts
    95
    Likes
    42
    The way it works changed recently. I think behaviour of this particular feature is part of the connected app on the watch.
    It is now set always to lowest brightness, previously it was using last automatic brightness of the face (which is set automatically using brightness sensor).
     
  3. JAL

    JAL Feb 26, 2018

    Posts
    4
    Likes
    0
    Thank's for the answer. So, can AOD be set to a higher brightness value via Connected APP?

    Kind regards!
     
  4. pfrasun

    pfrasun Feb 26, 2018

    Posts
    95
    Likes
    42
    No, it cannot. It is fixed set to lowest brightness (manual brightness setting affects only the watch face).
    Connected app is installed on both ends, phone (android) and watch, I mean the one in the watch in my answer.
     
  5. JAL

    JAL Feb 26, 2018

    Posts
    4
    Likes
    0
    OK so the only workaround might be to change manual brightness settings (default and AOD) on the specific watch face Thanks again for the info. Kind regards!
     
  6. pfrasun

    pfrasun Feb 26, 2018

    Posts
    95
    Likes
    42
    No, there is no workaround, it is set to lowest brightness. This setting cannot be modified by user.
     
  7. JAL

    JAL Feb 26, 2018

    Posts
    4
    Likes
    0
    OK I've got it.

    Best regards!